So you think that changing the ugly old carpet or floors vinyl with something fresh and beautiful and want to use tiles in place. I saw a lot of pictures in magazines designed for home, you have an idea of ??costs, and shop with the best selection, but I know where to start.
Well, looks like you already have a good start, there are some design ideas from magazines, you know where to buy materials, and you have an idea of ??costs, and decided to make the slope for you! The advice I give to you comes from my experience as a professional composer of tile in Phoenix, Arizona.
The first thing I think is what kind of surface that is to be that beautiful piece, wood or concrete. We found that surface preparation will determine how the tile will ensure that you have installed and how long it will take at home, and his face not want to do next year. Follow these basic steps before you make your first card
The surface
Look for defects, such as falls and bumps because the surface is smooth
If working with a wood surface is sure to make sure no protruding nails and is adapted to the infrastructure
When working with the appearance of cracks in concrete, I do not want more crack after installing tile surface
Make sure surface is clean before installation
These tips will save you time and frustration boot and make the experience more enjoyable for you. Next time you want to make sure that the measure area to sit. Do not want a 6 “cut in a wall and a 3″ cut on the other hand, would be very bad especially in a gateway. The first thing is to make sure you work with a square room? Believe me when I say that I do not know how many times I went into a new house and found one end of the room is 12 ‘and the other was 12 ’2 “Thanks to the development of the poor. This is good when working with large plates, but can be a real problem if they are small parts, like a bathroom. Here are some tips on placing the floor before installation.
Buy some tile spacers. They look like rubber track, which will determine the width of grout line and give you an idea of ??the pieces on the wall, and in most cases measured in price between the tiles.
Do not be afraid to put ceramic tile in both directions using the hardware to get an idea of ??what is going to look.
After determining if the room is square chalk line to establish a facility in both directions, this will help maintain the facility directly.
There are different types of adhesives for tile laying your concrete I use fine mortar, and use what is known as cement board, this can place on any surface wood and to eliminate the use of the filling line. The reason for this is when the wood is affected by temperature to expand and contract, and the idea of ??putty will allow you to change this, this is not a problem with the board, cement premix grout, grout and must be mixed before use. When mixing grout material, as is a bag of concrete mix and add water must be careful not to get the fine must be thick enough to be used with a trowel. I used a wheel barrel to mix and then transferred to a 5 gal bucket, this made it easier to handle. I also remember that when installing the boards to make sure not to leave air bubbles trapped under the tile. This song will make the brakes. I use the method is to put tiles by pushing down evenly until you see the beginning piece adhesive edges and then gently press the top of the board to hear any sound empty, this will tell if a pocket of trapped air and, if necessary, push a little more.
Now you have a few basic things to consider before tile project, and hopefully this will help you find satisfaction in your quest.
Related posts:
